It is strictly forbidden to touch the surface with hands or other non-adhesive materials, and it is strictly prohibited to repeatedly expose the surface. The bonded surface should be kept clean and dry, and generally cleaned with alcohol before use to avoid affecting the bonding fastness.
Accessories: cotton, industrial cleaner, rubber gloves.
1: Clean the surface of the device with non-depilating cotton cloth.
2: Use cotton cloth soaked in industrial detergent to clean the surface of the device and remove oil; In addition, do not touch the clean surface during installation.
3: Tear off the protective film on the back of the double-sided thermal tape side, and do not touch the rubber surface with your fingers.
4: Stick it on the surface of the device, from the center of the bonding area to the four sides of the soft pressure for five seconds, to ensure that the double back tape contact the surface of the heat dissipation device.
5: Tear off the protective film on the other side of the back glue according to the third and fourth steps of the same method, so that the heat-conducting double-sided tape and the chip stick firmly.
